Little Known Tips for Strong and Long Lasting Fences

Fence installation follows a procedure. Most building companies send their crews for site visits. They need to get a first-hand view before embarking on the project. It also helps the builder take note of special requirements such as elevations, vegetation and utility lines.

These tips come in handy during installation of fences:

Dry out

Once installed, allow the wall some time to dry up. Alert your family members of the wet paint. Restrain children and pets from touching the structure. Also, plan for repainting and mark the due dates. Ask your installer for guidance on this.

Fence off your pool

You must fence off your property if it has a swimming pool. You can opt to demarcate the pool area and have it secluded from the rest of the compound. The fence needs to have a height of four feet at a minimum. Also, there should be a gate, most appropriately, one that is self-closing. If you don’t have any experience in fence installation, check out fencing contractors in Melbourne that specialize in pool fencing.

The right hinges

Gates are massive structures. Undersized hinges cannot sustain the burden. Your builder must ascertain way ahead of time the hook size and the right posts, and the needed fence post supports to keep the gate in place. Wooden gates get heavy during the rainy season. Wood absorbs water and expands. In that case, the poles need to go deep.

Dealing with slopes

Not all properties are on a flat surface. Yours might be in a sloppy area. Elevation changes pose a challenge. Fortunately, by working with the best Houston, Texas fence contractor, you can overcome this through stepping. Builders prefer to set sections of a wall at a particular height as they progress.

The best side faces outward

While installing fences, the side that faces your neighbor’s property should be the good one. The posts and rails should face inside your compound. If you do it the other way round, residents next door may find it rude. Besides, fence construction standards require that the beautiful side face outwards.

Section spans

In every fencing type, you first set the posts. After that, you install the parts. The length of these sections is usually between six and eight feet. If you set posts at a distance of more than eight feet from each other, the fence will wobble. It may even collapse in extremely windy conditions.

Pour the concrete in

When putting in the concrete to hold a post firmly in the soil, there are two approaches. In the first one, you can take the dry mixture and put it around the pole before adding water. Easy, right? Perhaps it is only that the concrete will not set firmly. In the second approach, have the post in the hole and put the already mixed concrete around the post. As the cement dries, it will hold the post in place.

All fences have got two components:

Posts
Sections

Ensure that you sink fence posts at least two feet deep. Alternatively, one third of the post’s length should go into the ground. However, these distances vary depending on the local building codes. Your contractor should know what applies in your case.