Miter saw is a special type of saw (tool) used for wood works that require exact wood and moulding cuts — particularly angles. These are of different types based on the dimensions, angle, etc. This article aims to give you a brief introduction to these miter saw.
Different Types Of Miter Saw:
With a board level on the base of a miter saw, any calculated cut over the wide face considers a “miter” on any miter saw. Turn the board on its edge, put it against the fence, and you’ll be able to cut a “slope”. Generally, most saws slice from 90 to 45 degrees (two ways), and a few saws can slice up to 55-degree edges.
Saws begin to contrast when you take a gander at their edge width or blade diameter which is normally around 10 inches or 12 inches. The larger the cutting edge, the more profound and more extensive is its maximum cut. Note that, a 10-inch miter saw will cut a 2 x 6 at 90 degrees and a 2 x 4 at 45 degrees; a 12-inch miter saw will cut a 2 x 8 at 90 degrees and a 2 x 6 at 45 degrees.
They can also be classified on the basis of their movement. For example, the blade arm can simply rotate, or can both swing and slide. The first one is a basic miter saw whereas the second one is called a sliding miter saw. The sliding action is there to facilitate cuts on wider boards. Another type of saw is the Ridgid saw, you can read learn about these in detail and also about the ridgid saw review.
How To Use It?
Marking: Well to cut a piece of work, you need to first determine the position and the angle of contact so that you get the accurate cuttings. The position of contact is determined by the cut angle and the thickness of the piece. While marking the job, extend the line over the stock, match the blade with the piece by dropping it to check the alignment, and adjust the system accordingly prior to starting.
Cutting: While cutting the board, make sure that the greater part of its length is on the saw. In the event that the board is too long, stack a couple of scraps by the saw to help the overhanging board. In this way, you can stabilize the system while cutting and the results will be accurate and fast. Now, place the stock against the fence at the saw base, and freeze it with clamps or your hands cautiously at a distance no less than 6 inches from the blade. At exactly that point you should begin with the saw. Continuously keep your other hand on the saw handle. The two arms ought to be straight out before you, and your feet solidly planted so that you remain standstill during the cutting.
Begin the saw at the highest point of the working position and let the motor catch up the speed. Now, bring the saw down into the piece. When you are done, release the trigger and wait for the blade to stop before raising it.
